INSTRUCTION MANUAL
–
T229, T241 FRONT LOADER
51
Prior to entrance on the public roads you should:
−
detach the work tool,
−
set the boom of the Loader in the idle position (point of rotation of the tool at the min.
height of 25 cm above the ground),
−
make sure that the loader beam obscure the tractor lamps,
−
secure the controller (joystick) against accidental activation by sliding the lock bolt,
−
adjust the speed to the current conditions, avoid exceeding the speed of 15 km/h,
Figure 43.
Loader boom in the idle position
Before merging with the traffic on public roads, make sure that the tractor is fully
manoeuvrable. The pressure on the rear axle of the tractor must be at least 20% of the tractor
weight. If this condition is not met, an additional load must be added to the rear axle.
It is prohibited to drive on public roads with a tool installed on the
boom.
It is prohibited to transport loads on the Loader on public roads.
WARNING
WARNING
Summary of Contents for T229
