38
INSTRUCTION MANUAL
–
T229, T241 FRONT LOADER
To install a tool using the hydraulic system of the Loader, the first operations must be
carried out similarly to the installation of a mechanical tool:
−
drive up to the tool (1) placed on solid, level and even ground,
−
lower the Loader to move the coupling frame (2) below the hitch hooks of the tool (1),
−
set the locking device in the open position (see above),
−
lower the coupling frame (2) downwards,
−
carefully approach the tool,
−
place the tool hitches (1) in the coupling frame guides (2),
−
set the locking device in the locked position (see above),
−
connect the hydraulic lines of the tool to the hydraulic system of the cylinder, as
shown in Fig. 19.
5.2 Work Tools
The manufacturer offers different work tools as optional equipment of the Loader.
They may be purchased with the machine or at any other time.
Each work tool is provided with a nameplate.
Tools cannot be loaded to exceed the maximum load capacity specified on
the nameplate.
Make sure tha
t the connectors of the Loader’s hydraulic lines
connected to the tractor’s hydraulic system are not contaminated.
The attachment of a mechanical or a hydraulic tool should be
accompanied by an employee of the dealer service centre/manufacturer.
WARNING
WARNING
Summary of Contents for T229
