INSTRUCTION MANUAL
–
T229, T241 FRONT LOADER
53
9. Front Loader Storage
It is recommended to store the Loader in a dry area, protected against UV rays and
other harmful factors.
Secure the Loader with a waterproof tarpaulin or film if stored without roof protection.
After the end of the season, clean the Loader and check the protective coatings. All the
spots without a protective coating missing should be repaired at services.
Check the condition and legibility of the rating plate. In the case where it is destroyed
report at the service.
Check the condition and legibility of the pictograms. In the case where they are destroyed
replace them with new ones.
The Loader must be stored on solid, flat and level ground, supported by
two adjustable supports. Ensure a greater stability by storing the Loader
with an attached work tool (e.g. loose material bucket).
A stable storage position for the Loader is secured when
it is “laid down” (Chapte
r 8.1 Load Transport).
It is prohibited to service the Loader standing under its raised parts
during storage.
Connectors of hydraulic hoses must be secured against oil
leakage.
Store the Loader in an atmosphere free of aggressive agents (e.g.
ammonia, chemical agents)
WARNING
NOTE
WARNING
WARNING
Summary of Contents for T229
