A few general do’s and don’ts –
Do –
•
Read and adhere to manual
•
Use correct solution and brushes
•
Make sure silicone sleeve is always covering the stainless
steel conductor where the brush screws in
•
Make sure the silicone aero shield is always attached
•
Follow general maintenance points
Don’t –
•
Touch the brush when machine is connected to power
supply.
•
Touch the brush or unscrew brush immediately after use as
it will be hot
•
Touch the work piece near the weld/polished area just after
it has been polished as it will still be hot.
•
Use handle parallel or overhead, as solution may run back
down handle
•
Wrap or tie brush bristles to stop splaying of the bristles
•
Use any other brush or material other than supplied by
Metal Science Technologies (Use of other brushes/material
voids warranty)
Do’s & Don’ts
