9
MOWER OPERATION (CONT'D)
8. When the steering brake levers are released, the
machine will travel straight. To make a right turn,
squeeze the RH lever. To turn left, squeeze the LH
lever.
9. TO STOP, squeeze both levers, lock the neutral
latches, and move the speed adjustment lever to
neutral.
10. To move the machine in reverse, squeeze up on both
steering control levers.
5. Engage the cutter blades by pulling the blade clutch
switch into the ON position. Push the switch to the
OFF position to disengage the cutter blades.
390S0138
PULL UP TO ENGAGE
PUSH DOWN TO DISENGAGE
-NOTE-
When PTO is engaged or (possibly) disengaged,
a squealing sound from the underside of the
machine is normal. It is caused by the electric
clutch plates meshing as the mower comes up to
speed. For best equipment life, engage the
clutch with the engine at 3/4 throttle, not under
full load.
WARNING:
If you are not familiar with the operation of the
hydrostatic drive and zero turn feature, practice
turning and maneuvering with the hand controls
before engaging the cutter blades.
7. While squeezing the steering brake levers with both
hands, release both neutral latches.
-NOTE-
Top speed is suggested only for transport!
6. Release the parking brake. Move the speed adjust-
ment lever to the desired mowing speed.
11. To "freewheel" or move the machine around
without the engine running, turn the dump valve
levers located at the back of the pumps to the
"freewheel" positions (see Figure 1). To operate
the machine, the dump valve levers must be
returned to the closed positions.
Figure 1. Dump Valves
SWZ05DMPVLV
Dump Valve Levers
(closed position)
BELT TENSION
Stop engine and remove the key from the ignition
before making any adjustments. Wait for all moving
parts to come to a complete stop before beginning
work.
CAUTION:
-NOTE-
All the belts on the SWZU are spring-loaded and
do not require adjustment. Check the belts for
excessive wear or damage daily for the first week.
After the first week, check the belts monthly.
1. Remove the belt covers.
2. Inspect the belts for wear, cracking, or glazing.
Contact your Scag dealer if any unusual wear is
noted.
3. Replace the belt covers.
Summary of Contents for SCAG POWER EQUIPMENT SWZU Series
Page 27: ...23 NOTES...
Page 47: ...43 WIRE HARNESS ADAPTER PART NO 481717 KAWASAKI 16 HP 17 HP 19HP SWZU06WH481717...
Page 51: ...47 NOTES...
Page 54: ...2 3 NOTAS...
