SAFETY
Please pay close attention to the safety notices in this section. Disregarding these
notices may lead to serious injury and/or damage to the unit.
ATTENTION
To minimize shock and fire hazards, be sure not to overload electrical outlet. Designate
one outlet for your unit only.
Do not use extension cords.
Do not put your hands under the unit when moving it.
When the unit is not in use for a long period of time, unplug electrical cord from outlet.
After unplugging the unit, wait at least 10 minutes before plugging it in again. Failure to
do so could cause damage to the compressor.
UNPLUG CORD
To minimize shock and fire hazards do not plug or unplug the cord with wet hands.
During maintenance and cleaning make sure unit is unplugged.
PROPER GROUNDING REQUIRED
To minimize shock and fire hazards make sure the unit is properly grounded.
WARNINGS
Do not attempt to remove or repair any component unless instructed by a factory
service representative.
Make sure the unit is not resting on or against the electrical cord and plug.
To minimize personal injury, do not hang on the doors.
Do not store any flammable and explosive gas or liquids inside the unit.
Do not attempt to alter or tamper with the electrical cord or plug.
CLEANING
CONDENSER COIL
For efficient operation, it is important that the condenser surface be kept free of dust, dirt and lint
It is recommended that the condenser coil and fins be cleaned at least once per month.
Clean with a commercial condenser coil cleaner available from any kitchen equipment dealer.
Brush the condenser fins from top to bottom, not side to side.
FAN BLADES AND MOTOR
If necessary, clean the fan blades and motor with a soft cloth.
UNIT INTERIOR
When cleaning the cabinet interior, use a solvent of warm water and mild soap.
Do not use steel wool, caustic soap, abrasive cleaners or bleach. These items can damage
the stainless steel surface.
Wash door gaskets on a regular basis, preferably weekly. Simply remove door gasket from
the frame of the door, soak in warm water and mild soap for 30 minutes, dry with a soft
cloth and replace.
Check door gaskets for proper seal after they are replaced.
Periodically remove the shelves and pilasters from the unit and clean them with mild soap
and warm water. To remove the pilasters you must first remove the shelves and the shelf
brackets. Then simply pull the pilasters up an out. Reinstall in the reverse order.
WARNING: Disconnect power cord before cleaning any parts of the unit.
OVEN
CLEANER
ABRASIVE
DETERGENT
ST E
E L
WOOL
NEUTRAL
SOAP
•
•
•
•
•
•
•
•
•
•
•
•
•
