background image

4

MRA - Series | Version 1.07

Safety

Tips and recommendations

It is necessary to observe the safety notes quoted in 
these operating instructions in order to reduce the risks 
for personal injuries and damages to property.  

2.2 Qualification of the staff

This manual is intended for:

- the operators,

- the staff for maintenance work.

  

Only persons who are expected to carry out this work re-
liably are permitted for all work. Persons whose reactivity 
z. As influenced by drugs, alcohol or drugs are not allo-
wed.

This manual identifies the qualifications of the persons li-
sted below for the different tasks:

Operator:

The operator has been instructed in a briefing by the 
operator about the tasks assigned to him and possible 
dangers of improper behavior. The operator may only 
carry out tasks that go beyond normal operation if this is 
specified in this operating manual and the operator has 
expressly entrusted this to him.

Personnel:

Due to their technical training, knowledge and experi-
ence as well as knowledge of the relevant standards and 
regulations, qualified personnel are in a position to carry 
out the work assigned to them and to recognize potential 
dangers independently and to avoid hazards.

Manufacturer:

Certain work may only be carried out by specialist per-
sonnel of the manufacturer. Other personnel are not au-
thorized to carry out this work. To carry out the work, 
contact our customer service.

2.3 Personal protective equipment

The personal protective equipment serves to protect per-
sons against impairments of safety and health while wor-
king. The staff has to wear personal protective equip-
ment while performing different works on and with the 
device which are indicated in the individual paragraphs 
of these instructions. 

The personal protective equipment is explained in the 
following paragraph: 

WARNING!

This combination of symbol and signal words indi-
cate a possibly dangerous situation which may lead 
to death or severe injuries if they are not avoided. 

CAUTION!

This combination of symbol and signal words indi-
cate a possibly dangerous situation which may lead 
to minor or light injuries if they are not avoided. 

NOTE!

This combination of symbol and signal words indicate 
a possibly dangerous situation which may lead to 
property and environmental damages if they are not 
avoided.

Tips and recommendations

This symbol highlights useful tips and recommenda-
tions as well as information for an efficient and trou-
ble-free operation. 

Tips and recommendations

All persons involved in operation and maintenance 
must

-  have the required qualifications.

-  Pay close attention to these operating instructions.

Eye protection

The goggles protect the eyes from flying parts and 
liquid splashes.

Protective gloves

The protective gloves serve to protect the hands 
against sharp components as well as against fric-
tion, abrasions or deep injuries.

Summary of Contents for 3772992













Reviews: