6
MRA - Series | Version 1.07
Technical Data
4
Technical Data
4.1 Table
* Performance data based on material with tensile strength 400 N / mm²;
** for stainless steel (VA): factor 0.67
4.2 Type plate
Fig. 2: Type plate
5
Transport, Packaging and Sto-
rage
5.1 Delivery
Check the notching machine after delivery for visible
transport damage. If the notching machine is damaged, it
must be reported immediately to the transport company
or the dealer..
Transport
Improper transport of individual devices, packaged or
unpacked unsecured devices that are stacked on top of
or next to each other is prone to accidents and can
cause damage or malfunctions for which we do not pro-
vide any liability or guarantee.
Transport the scope of delivery secured against shifting
or tipping with an adequately dimensioned industrial
truck to the installation site.
General hazards during internal transport
The transport may only be carried out by authorized and
qualified persons. Act responsibly when transporting and
always consider the consequences. Refrain from daring
and risky actions.
Inclines and slopes are particularly dangerous (e.g.
driveways, ramps and the like). If it is unavoidable to
drive on such passages, special care is required.
Before starting the transport, check the transport route
for possible hazards, unevenness and imperfections as
well as sufficient strength and load-bearing capacity.
Hazardous areas, bumps and imperfections must be in-
spected prior to transport. The removal of hazardous
areas, bumps and obstructions at the time of transport by
other employees leads to considerable dangers.
Careful planning of internal transport is therefore essen-
tial.
5.2 Packaging
All packaging materials and packaging aids used in the not-
ching machine are recyclable and must always be recy-
cled.
Cardboard packaging components are shredded and sent
to the waste paper collection.
The foils are made of polyethylene (PE) and the upholstery
parts are made of polystyrene (PS). These materials are to
be handed in to a recycling center or to the responsible wa-
ste disposal company.
Technical Data
MRA 2
MRA 3
Pipe diameter*
[mm]
28 / 34 / 43
50 / 61
Max. Wall thick-
ness*
construction steel
aluminium
copper
brass
stainless steel**
3 mm
4,5 mm
4 mm
4 mm
2 mm
3 mm
4,5 mm
4 mm
4 mm
2 mm
Notcher dimensi-
ons without lever
LxBxH [mm]
195x160x80
205x160x105
Notcher dimensi-
ons with lever
LxBxH [mm]
1060x160x80
1090x160x105
Weight
8 kg
15 kg
NOTE!
Protect the Manual Pipe notcher from moisture.
CAUTION!
Risk of injury from devices fall over and falling down-
from forklifts, pallet trucks or transport vehicles.
Only use means of transport and load attachment
means that can take the total weight.
CAUTION: RISK OF TOPPING OVER
The device may not be lifted more than 2cm unsecu-
red.
Employees must be outside the danger zone, the
reach of the load.
Warn employees and make employees aware of the
risk.
