8
MRA - Series | Version 1.07
Operation
8
Operation
8.1 Workflow
Step 1: Fix the notching machine horizontally or vertically
on a suitable work table using the holes.
Step 2: Open the tool with the release lever and insert
the pipe end into the appropriate opening.
Step 3: Make the cut by operating the release lever and
remove the workpiece.
9
Care, Maintenance and Repair
9.1 Cleaning and lubrication of the ma-
chine
The notching machine should always be cleaned after
each use.
Sweep or wipe all open machine parts with a broom or
cloth at regular intervals.
Treat bare metallic work surfaces with anti-rust spray.
Lubricate all moving parts and bearings daily before star-
ting work.
WARNING!
Risk of injury!
There is a risk of injury to the operator and other per-
sons if they do not adhere to the following rules.
- The operator may not work while under the influ-
ence of alcohol, drugs or medication.
- The operator must not work when he is tired or suf-
fering from concentration-impairing illnesses.
- The notching machine may only be operated by one
person. Other persons must keep away from the
work area during operation.
DANGER!
Risk of injury!
When working on the notching machine,
- is to wear tight-fitting clothing.
- no jewelry may be worn.
- Do not wear scarves, ties or similar.
- For long hair, a hairnet must be worn.
Wear safety glasses!
Wear safety gloves
ATTENTION!
Risk of crushing!
When working with the notching machine can cause
bruising of the upper limbs.
DANGER!
Always only one pipe, never work on several pipes at
the same time.
Before starting work, check that the knives of the not-
ching machine are sharp and there are no chips in
the tool.
Tips and recommendations
Do some test cuts before you start production!
Tips and recommendations
To ensure that the notching machine is always in
good working condition, regular care and main-
tenance work must be carried out.
WARNING!
Danger due to insufficient qualifica-
tion of persons!
Insufficiently qualified persons can not assess the
risks involved in repairing the notching machine and
expose themselves and others to the risk of serious
injury.
All maintenance work should only be carried out by
qualified persons.
DANGER!
Never use solvents to clean plastic parts or painted
surfaces. A surface release and consequential
damage may occur.
Wearing safety gloves!
