12
AKM-Series 220 | Version 1.07
Setting up
Fig. 10: Positioning with the crane
Step 6: Remove the front cover screws and front cover
(Fig.11).
Step 7: Remove the plug 3 (Fig.11).
Fig. 11: Filling the oil tank
Step 8: Fill the hydraulic oil into the hydraulic oil circuit
(approx. 20 litres) until the oil level reaches the
4/5 position of the oil level indicator 2 (Fig. 11).
Step 9: Check that the pressure gauge 4 (Fig. 11) is 150
kg/cm
2
(2100 psi).
7.2 Electrical connection
With the 3-phase 400 Volt / 50 Hz motor, the notching
machine should be connected to a standard 400V
mains supply.
Mains connection cable and extension cable must have
5 wires = 3P + N + PE (3/N/PE) with a cross-section of
1.5 mm² mm each.
ATTENTION!
The machine is delivered unfilled. Before commis-
sioning, hydraulic oil must be filled into the tank.
Only use suitable hydraulic oil for refilling.
ATTENTION!
When starting up the machine, only use the feet to
operate the foot pedal!
Never use your hands or any available aids to ope-
rate the machine via the foot pedal.
This will prevent injuries to persons and damage to
the machine.
NOTE!
After installation, remove the grease from the blank
metal parts which has been applied for protection.
- Use common solvent for this purpose, e.g. petroleum.
- Do not use water, nitro solvents, etc.!
After the machine has been thoroughly cleaned, all
blank parts must be lightly oiled. Only use resin- and
acid-free machine oil!
Tips and recommendations
For a safe stand, it is recommended that the
machine is fastened to a firm, stable and level
ground via the holes provided in the machine base.
Danger!
Risk of fatal electric shock!
Contact with live components may result in fatal
injury. Switched-on electrical components can make
uncontrolled movements and lead to serious injuries.
ATTENTION!
Never operate the foot pedal when:
- The electrical supply or air pressure supply is not
yet connected.
- Carry out maintenance.
ATTENTION!
All operations on the electrical installation and on the
electrical equipment may only be carried out by qua-
lified electricians!
Summary of Contents for 3834200
Page 32: ...www metallkraft de ...
