Operation
AKM-Series 220 | Version 1.07
19
B:
Grid plate, angle wheel
D:
Inner scale
E:
Outer scale
.
The two reference display groups can both be set to the
left and to the right within a range of up to 45°.
Fig. 28: Angle adjustment directions of the reference display groups
9 Operation
ATTENTION!
If the setting of the knife position is changed, the
position of the outer stop must be adjusted.
WARNING!
Danger to life!
Failure to observe the following rules entails a risk of
fatal injury for the operator and other persons.
- The operator must not work under the influence of
drugs, alcohol or medication.
- The operator must not work in case of tiredness or if
suffering from an illness that impairs concentration.
- Die Ausklinkmaschine must be operated by one
person only. Additional persons must keep out of
the work area during operation.
DANGER!
Risk of injury!
While working on the notching machine:
- tight clothing must be worn.
- No jewellery may be worn.
- No shawls, ties or the similar must be worn.
- A hair net must be worn for long hair.
DANGER!
Risk of injury!!
There is a risk of injury to the upper limbs (e.g.
hands, fingers).
ATTENTION!
Never step on the foot pedal if:
- You have connected the electrical supply and the
air pressure supply.
- You want to start the application during operation.
- You have completed a started maintenance.
ATTENTION!
- Never change the settings for the hydraulic system.
This is especially true for valves present there.
- Never change the setting of the cutter bar stroke li-
mit.
- Only operate the machine from the front.
- Ensure that the workpieces are fixed when working.
Use the stops for this purpose.
- Adjust the stops only when the machine is swit-
ched off (main switch in the position "OFF").
- When setting the stops, observe the minimum and
maximum cutting length.
- When adjusting the inner stop, make sure that no
collision with the upper knives can occur.
- When cutting metal strips to length, make sure that
the cutting line is not longer than the knife length.
- Always place the metal sheets over their entire sur-
face on the worktable. If necessary, support late-
rally protruding material with stable and stable ma-
terial stands.
Wear hearing protection!
Use protective goggles!
Use protective gloves!
Safety boots
Use protective clothes!
Summary of Contents for 3834200
Page 32: ...www metallkraft de ...
