Maintenance and repair
AKM-Series 220 | Version 1.07
21
9.4 Workflow
Step 1: Check the mains plug, the cable and the pedal
connection. The machine must be switched off.
Step 2: Check the hydraulic oil level.
Step 3: Check all fuses in the control cabinet.
Step 4: Adjust the cutting gap.
Step 5: Adjust the angled stops to the notch dimension.
Step 6: Set the main switch on the switch cabinet from
position 0 to position 1.
Step 7: Press button (Pos. 6, Fig. 29). The hydraulics are
in operation.
Step 8:
For manual operation:
Set the switch (Pos. 5, Fig. 29) to the right posi-
tion, the lamp lights up.
As long as the foot pedal (Pos. 8, Fig. 29) is
pressed, the top bar moves down and stops
when the bottom limit switch is touched. The
lamp goes out.
Step 8:
For pedal operation:
Set the switch (Pos. 5, Fig. 29) to the left posi-
tion, the lamp lights up. As long as pedal (Pos.
8, Fig. 29) is pressed, the top bar moves down
and stops as soon as the bottom limit switch is
touched. The machine stops cutting and the top
bar returns to the top position. .
Step 9: Place the workpiece on the work surface and
against the stops.
Step 10: Press the pedal for the cut depending on the
setting.
Step 11: Remove the workpiece.
Important:
Press the EMERGENCY OFF button (Pos. 1,
Fig. 29) in case of the danger. The movement
of the top beam stops and the top beam auto-
matically returns to the top position.
9.5 Shut down the machine
Step 1: Turn off the main switch.
Step 2: Disconnect the power plug.
10 Maintenance and repair
Tips and recommendations
Before starting the production, make a few test cuts!
Tips and recommendations
To keep the notching machine in a good operating
condition, regular care and maintenance work must
be carried out.
WARNING!
Danger from the insufficient qualification of
persons!
Insufficiently qualified persons cannot assess the
risks involved in repair work on the notching
machine and expose themselves and others to the
risk of serious injury.
Have all maintenance work carried out by qualified
personnel only.
DANGER!
Before starting any maintenance work, make sure
that you do the following:
- The MAIN switch is set to OFF and locked against
unintentional power-up.
- The compressed air supply is disconnected.
DANGER!
Never operate the foot pedal control before you
have connected the electrical and pneumatic sup-
ply!
DANGER!
Risk of death due to electric shock!
Contact with live components may result in fatal
injury.
- Always disconnect the mains plug before starting
cleaning and maintenance work.
- Connections and repairs to the electrical equip-
ment may only be carried out by a qualified electri-
cian.
NOTE!
After cleaning, maintenance and repairs, make sure
that all panels and protective guards are once again
correctly in place on the machine and that there are
no tools on the inside or outside of the machine.
Damaged protective guards and machine parts must
be professionally repaired by an approved work-
shop, or replaced.
Summary of Contents for 3834200
Page 32: ...www metallkraft de ...
