22
AKM-Series 220 | Version 1.07
Maintenance and repair
10.1 Cleaning and lubricating the machine
The notching machine should always be cleaned after
each use.
Clean the worktable regularly to prevent material frag-
ments from damaging the machine, impairing the ope-
ration or injuring the operator.
Sweep or wipe all open machine parts with a broom or
cloth at regular intervals.
Treat bare metal work surfaces with anti-rust spray.
Lubricate all moving parts and bearings once a month.
10.2 Maintenance of the machine
If the notching machine does not function properly, con-
tact a specialist dealer or our customer service. The
contact details can be found in chapter 1.2 Customer
service.
10.2.1 Hydraulic system
Maintenance and repair work on the hydraulic system
may only be carried out by specialists with special hy-
draulic knowledge.
Before starting any maintenance work, make sure that
the hydraulic system is pressureless. To do this, ma-
nually lower the cutter bar and switch off the machine
immediately at the main switch.
Change oil filter
A clean oil filter is a precondition for trouble-free opera-
tion of the hydraulic system. Replace the oil filter after
the first 3000 operating hours. In the further operating
process it is necessary to replace the filter in an interval
of 5000 operating hours. This work may only be carried
out by a specialist with special hydraulic knowledge.
Check filling level in hydraulic oil tank
Regularly check the level on the sight glass of the hy-
draulic oil tank. Carry out the check daily during the first
week after initial commissioning. A weekly check is then
required.
DANGER!
When carrying out care, maintenance and repair
work, pay attention to protruding parts in order to
avoid injuries!
DANGER!
When carrying out maintenance and repair work,
ensure that the compressed air supply hose is dis-
connected and that the safety device is connected
to the air filter/reducer/lubricator unit.
ATTENTION!
- Before starting cleaning and lubrication, switch off
the machine and pull out the mains plug!
- Never use solvents to clean plastic parts or painted
surfaces. Loosening of the surface and resulting
consequential damage can occur.
- Never use water nozzles for cleaning!
ATTENTION!
- Maintenance and repair work may only be carried
out by qualified personnel.
- Only use original spare parts.
- All protective and safety devices must be mounted
again immediately after completion of repair and
maintenance work.
DANGER!
- There is a risk of injury from hydraulic oil splashing
out under high pressure.
- Pay particular attention to the fact that parts of the
hydraulic system are under high pressure after ad-
justing the cutting gap and changing the blades.
- Switching off the drive motor does not ensure that
the entire hydraulic system is depressurised.
- Do not open any screw connections until you are
absolutely sure that the hydraulic system is com-
pletely depressurised!
- There is a risk of injury from hot surfaces. Allow the
hydraulic system to cool down before working on it.
ATTENTION!
An incorrect filling level can cause damage to the
machine.
- Top up the hydraulic oil in good time.
- Do not mix different types of oil.
- Only use oil from the same manufacturer.
Summary of Contents for 3834200
Page 32: ...www metallkraft de ...
