Safety
AKM-Series 220 | Version 1.07
5
Operator
The operator is instructed by the operating company
about the assigned tasks and possible risks in case of
improper behaviour. Any tasks which need to be per-
formed beyond the operation in the standard mode
must only be performed by the operator if it is indicated
in these instructions and if the operating company ex-
pressively commissioned the operator.
Electrically qualified person
Electrically qualified person is due to their professional
training, knowledge and experience as well as knowl-
edge of the relevant standards and regulations, in a po-
sition to carry out work on the electrical systems and to
in-dependently recognize and avoid possible dangers.
Qualified personnel
Due to their professional training, knowledge and expe-
rience as well as their knowledge of relevant regulations
the specialist staff is able to perform the assigned tasks
and to recognise and avoid any possible dangers them-
selves.
Manufacturer
Certain works may only be performed by specialist per-
sonnel of the manufacturer. Other personnel is not au-
thorized to perform these works. Please contact our cus-
tomer service for the execution of all arising work.
2.4 Personal protective equipment
The personal protective equipment serves to protect
persons against impairments of safety and health while
working. The staff has to wear personal protective
equipment while performing different works on and with
the notching machine which are indicated in the individ-
ual paragraphs of these instructions.
The personal protective equipment is explained in the
following paragraph:
2.5 General safety regulations
Please observe the following points:
- Use the guards and secure them securely. Never
work without guards and keep them functional.
- Always keep the machine and its working environ-
ment clean. Provide adequate lighting.
- Always secure your workpiece when working with
suitable clamping devices. Ensure a sufficient con-
tact surface.
- Check that the fixed hand guards are correctly instal-
led.
- The design of the notching machine must not be
changed and it must not be used for purposes other
than those foreseen by the manufacturer.
- Never work under the influence of illnesses that im-
pair concentration, drugs, alcohol or medication.
- Keep children and persons unfamiliar with the notch-
ing machine away from their work environment.
- Do not pull the power cord to unplug the plug from
the outlet. Protect the cable from heat, oil and sharp
edges.
- Immediately eliminate malfunctions that reduce
safety.
- Protect the notching machine against humidity (short-
circuit hazard!)
- Before each use of the notching machine, make sure
that no parts are damaged. Damaged parts must be
replaced immediately to avoid sources of danger.
- Before starting the machine, make sure that there are
no dangerous environmental conditions for the ope-
rator which could pose a danger during operation.
- Make sure that there are no tools or objects inside or
on the machine before starting the machine.
- Do not overload the notching machine! You will work
better and safer in the specified performance range.
- Only use original spare parts and accessories in or-
der to avoid possible dangers and accident risks.
Protective goggles
The goggles protect the eyes from flying parts and
liquid splashes
Hearing protection
The hearing protection protect the ears from hea-
ring damage caused by noise..
Breathing protection
Breathing protection serve to protect the respiratory
tract and lungs from the absorption of dust particles.
Protective gloves
The protective gloves serve to protect the hands
against sharp components as well as against fric-
tion, abrasions or deep injuries.
Safety boots
Safety boots protect the feet from being crushed, fal-
ling parts and slipping over on slippery ground.
Protective clothes
Protective clothes are made of a tightly fitted fabric
without the protruding parts of low tear strength.
Summary of Contents for 3834200
Page 32: ...www metallkraft de ...
