- 12
SAFETY EXPLANATIONS
The Machine is equipped with a hydraulic check valve system in order to relieve the excess
pressure when the machine is overloaded, thus preventing serious damage to the machine and the
worker. All safety precautions are for your safety, which we believe will be obeyed by our customers
unasked.
SAFETY UNITS
Quick stop button use on the panel and main body
Protective barriers
In this manual are summarized the important information for work safety. The following
security explanations and instructions are considered as the essential information for your safety.
Any and all persons who must operate the machine should be firstly trained well in terms of the
operation and safety information and instructions. For this purpose, more copies of this manual shall
always be asked from the supplier. It should be clearly fixed out that which persons will have the
responsibility to change and arrange tools and blades. These persons need to be essentially trained
in terms of this subject.
All the METALLKRAFT machines are delivered as standard with a safety equipment,
such equipment is for a high and general work safety. For this purpose, the machine should only be
used in accordance for those purposes for which it has been constructed.
The most dangerous and probable deviations as to the construction limits of the
machine are estimated to be as follows:
1.
Machining of other materials as unalloyed steel (45 kg/mm
2
)
2.
Erroneous use of the fixing installation
3.
Punching or fixing very small work pieces, as these will easily cause the operators be subject
to danger zones.
Should the additional tools be necessary to be used on the machine, which are not foreseen
by the producer, it should be re-verified whether or not there is sufficient safety and security against
work accidents. For this purpose, the producer should be contacted for advice when deemed
necessary. All the maintenance works should be carried out by sufficiently qualified expert personnel.
Particular attention should be paid to the correct assembly and arrangement of the hole stamps,
cutting cases, blades and other tools. In order to enable us and yourselves to fulfill our mutual and
common responsibility for all people, we request you to read this manual very carefully before putting
the machine into operation and to obey all the safety information and instructions.
Attention:
All the parts of the machine dyed in red are danger zones and particular
attention should be paid in such zones!
All the operators should be instructed in order not to place their fingers or other body parts
near, in or under the parts of the machine colored in red. There is the risk of losing the body parts
when these are placed in such zones!
