- 13
All the safety components and fixing installations that should be removed for maintenance
purposes, should be remounted again before the machine is reoperated. The operators should wear
the clothing described by the employer. The producer recommend the use of protection eyeglasses
against eventual stamp breaks and shoes with steel covering in order to prevent foot of the operator
against falling materials.
SAFETY RULES
1.
The assembly and adjustment works, tool changes and maintenance services shall only be
realized by the technical personnel qualified for this purpose, who should strictly obey the
instructions of the producer.
2.
Remove any oil remaining, cuttings and other impurities from the working zone where such
remaining might be left the previous operator.
3.
Before the starts working on the machine, the operator should make sure that all the tools are
in a perfect condition.
4.
Any leakage and order of hole stamps and cutting cases, blade tolerances etc. should be
checked after each tool change and be readjusted if necessary.
5.
The scraper should always be adjusted according to the material resistance to be machined.
Unequal scraping forces can easily result with tool breaks.
6.
Never punch any material which stronger than the diameter of the hole stamp. In this case, the
hole stamp can be overloaded and easily break.
7.
Always punch trough holes. Never punch base holes, unless the tool is clearly foreseen for
this purpose. The lateral elongation force, which occurs during punching of the base holes,
might excessively press the hole stamp against the cutting case and consequently an easy
break might result.
8.
The machine has been designed in a manner to work with the pieces which can be placed
without having subjected the fingers or hands into the danger zone. For punching, mortising
and profile cutting of the short pieces ( for instance small sheet metal parts ), special tools,
scrapers and security components are pieces should be placed into the machine and taken
back suitable holding tools.
9.
Regularly check the screw connections and other fixings of all the blades and other parts as
well as the safe seating of the hole stamp and cutting cases. For example, should the hole
stamp ( punch ) get loose during the operation, there occurs the danger that the hole stamp
inclined over the cutting case so that the tool might break.
10. Before each tool change, make sure that the machine is disconnected from main switch.
11. Completely disconnect the machine from the net before you carry out any maintenance work.
12. Never let the machine function without any inspection.
