- 21
MITRING ANGLE 45 DEGREES
Since the introduction of the requirements for health and safety, the accessibility and distance
between hold-downs and blades have been amended.
To this effect the operation cutting angle in the angle cutting station requires the following
simple hold-down adjustment.
Once the hold-down is secured for cutting as position 3, it is also possible use the hold-down
for cutting angle at 90 degrees if required.
STANDARD HOLD-DOWN
POSITION
ROTATE AND SECURE THE
HOLD-DOWN TO THE
MACHINE FOR CUTTING
REMOVE THREE SECURING
SCREWS & INVERT
HOLD-DOWN AS ABOVE
