- 23
SHEARING, PROFILE SECTION CUTTING
The shearing unit has been equipped with a simple and strong fixing installation that can be
arranged at any material thickness within the cutting capacity of the machine. A shearing delivery table
having adjustable quides has been constructed in order to allow a correct delivery of the material. The
guiding can be arranged in a manner to allow the angle cuts up 45
0
for flat bar material or the cutting
of flange of angle profiles, which have been previously cut at the inclined cutting station. Always place
the material from the entry side of the machine and make sure that the material gets fixed by a
correctly adjusted fixing installation. If a full a full cutting is required, the biggest possible dimensions
for the material to be cut at angles, amount to 70x70x10.
In case the shear blade should be grounded, grind only the cutting surfaces. A re-grinding is
possible up to a maximum depth of 0.8 mm. After the grinding the blades should be adjusted to a play
of 0.1 mm.
Shows special section blades available
