12
PRM FH | Version 1.04 | EN
Transport, Packaging, Storage
Danger points, unevenness and disturbance points must be inspected before
transport. The removal of danger spots, disturbances and unevenness at the
time of transport by other employees leads to considerable dangers.
Careful planning of internal transport is therefore essential.
.
Transport with a forklift / pallet truck:
For shipping, the machine is firmly mounted on a pallet so that it can be trans-
ported by forklift or pallet truck.
Transport by crane:
The machine can be set up with a crane in a suitable location. To do this, the
machine must be attached to the crane in accordance with the regulations
(Fig. 4). The attachment points on the machine are to be used.
For transport, all rollers must be fixed and all covers fastened to the machine
frame.
The machine must not be rocked by the crane during transport
Fig. 4: Transport of the ring bending machine
5.2 Packaging
All packaging materials and packaging aids used in the machine are recycla-
ble and must always be recycled.
Cardboard packaging components must be shredded for collection of waste
paper.
The foils are made of polyethylene (PE) and the upholstery parts made of poly-
styrene (PS). These substances must be handed over to a recycling center or
to the responsible disposal company.
5.3 Storage
The machine must be thoroughly cleaned before being stored in a dry, clean,
dust- and frost-free environment. It must not be stored in a room with strongly
oxidizing chemicals.
If the machine must be stored in a damp room, all electrical components as
well as the hydraulic equipment must be protected with moisture-absorbing
agents. All bare metal parts (upper and lower tools) must also be greased
against rusting.
DANGER!
Danger to life due to falling of the load!
Falling loads can cause serious injury or even death.
- Never step under suspended loads.
- Fix loads carefully.
- When leaving the workplace, lower the load.
