16
PRM FH | Version 1.04 | EN
Assembly
Setting up the ring bending machi-
ne
The ring bending machine can be positioned horizontally or vertically for ma-
chining workpieces (Fig. 9).
Fig. 9: The ring bending machine PRM FH - horizontal and vertical use
Step 1: Use a spirit level to check the surface for horizontal alignment and
even out any slight unevenness.
Step 2: Place the ring bending machine on a level, firm and vibration-free sur-
face.
Step 3: Fasten the ring bending machine to the surface with ground anchors.
Step 4: Connect the portable control panel to the machine using the spacer
rod.
Fig. 10: Anchoring the ring bending machine
WARNING!
Crushing!
The machine may tilt during deployment and cause serious
injury.
- The machine must be set up by at least 2 people together.
Use protective gloves!
Wear safety boots!
Wear protective clothes!
