Set up and connection
RBM E | Version 1.07
15
Step 1: Check the ground for a horizontal alignment, if necessary, compensate
for slight unevenness.
Step 2: Attach the round bending machine with ground anchors to the ground
and align horizontally with a spirit level.
7.2 Danger zones
The plate rolling machine is provided with the necessary protective equipment
to prevent injuries that may be caused by the worm gear or other gears. Ano
-
ther area of danger that must be carefully observed during the machining
process is the turning range of the rollers.
The danger area shown below must be kept clear during operation.
Fig. 9: Danger zones
Wear protective clothing!
NOTE!
After setting up, remove the protective agent from the bare
metal parts, which have been applied to protect against
rusting.
- Use usual solvents.
- No water, no nitrolic solvents or similar use!
NOTE!
The moving parts must be free of dirt and dust.
- If necessary, lubricate the moving parts as listed in the
chapter on cleaning and maintenance.
Danger zone
Safety line
