20
RBM E | Version 1.07
Commissioning
The material should meet the following requirements:
- Dry and clean, free of oil.
- The diameter must correspond to the specifications.
- The material should have a degree of hardness throughout.
- Buying high quality material is advisable
- The surface of the areas to be bent should be smooth.
8.1 Operation
The RBM E models have a driven rear roller. It is moved by the engine and a
transmission system. The lower roller is driven by the transmission system.
Therefore, the bending process is simple and smooth; however, some experi
-
ence is needed to work efficiently.
A complete bend with one pass is not possible. To get the desired radius, se
-
veral passes are required. Narrow arcs and full radii always require multiple
passes.
NOTE!
It is important to thoroughly clean the rollers to avoid pos
-
sible slippage of the profile due to grease residues on the
rollers.
DANGER!
- The operator should have basic knowledge of this type of
machine.
- Operators should not wear loose clothing, necklaces, rings,
etc. to prevent them from being pulled into the running ma
-
chine.
- If faults occur, immediately actuate the EMERGENCY
STOP button.
CAUTION!
First read the operating instructions!
Please read the operating instructions completely before
you start the machine for the first time!
DANGER!
Before using the round bending machine for the first
time, lubricate the chains and bearings!
We assume no liability for damage due to improper commis
-
sioning.
DANGER!
When operating the rollers: Do not drive the rollers against
the lower stop!
