Commissioning
RBM E | Version 1.07
25
Bending process
Step 1: Before conical bending, the sheet must be pre-bent at the ends with
parallel rolls.
Step 2: Thereafter, the machine must be prepared for conical bending as
follows:
Move the lower roller and the rear roller to the lowest position.
Fig. 17: Conical bending: tool (left) and couplings (right)
Release the fastening bolts of the couplings. Pull off couplings so that only one
side of the rollers moves. Use the handwheel to tilt the rollers to the desired
position for conical bending.
Fig. 18: Conically bending, preparation
Clutches
Conically-bending tool
