12
RBM 305 | Version 2.02
Care, maintenance and repair
Fig. 15: Conically bending
Normal bending after conical bending
After conical bending, the rollers must be brought back
into parallel position.
Step 1: Use the handwheels to bring the guide roller and
the lower roller in parallel position to the upper
roller.
Step 2: Lock the rollers.
Step 3: Check the parallelism of the rollers with a gauge.
Removal of the workpiece
Step 1: Pull the locking handle out
Step 2: Pull the guide roller out to the front
Step 3: Remove the guide roller from the anvil
Step 4: Take the formed sheet from the roll.
Step 5: Reassemble the roller in reverse order and lock
the roller.
Fig. 16: Swivel guide roller
8.5 Bending wires
Use the smallest possible notch on the lower roll to bend
your wire. Slide the wire into the correct notch and turn
the handle to shape it. The remaining procedures and
adjustments are identical to those of bending a sheet.
Fig. 17: Bending of wires
9
Care, maintenance and repair
WARNING!
Never change the safety device. Never try to acti
-
vate a function of the machine when the top roller is
open.
Tipps und Empfehlungen
To ensure that the bending machine is always in
good operating condition, regular care and main
-
tenance work must be carried out.
DANGER!
Danger due to insufficient qualifica
-
tion of persons!
Insufficiently qualified personnel can not assess the
risks involved in maintenance work on the machine
and expose themselves and others to the risk of
serious injury.
- All maintenance work should only be carried out by
qualified persons.
NOTE!
Before servicing and maintaining the plate rolling
machine, the maintenance instructions must be care
-
fully read. The handling of the plate rolling machine is
only permitted to persons who are familiar with the
plate rolling machine.
