Intended use
RBM 305 | Version 2.02
5
2.4 General safety regulations
Please note the following:
- Use the guards and secure them securely. Never work
without protections and get them working.
- Always keep the machine and its working environment
clean. Ensure adequate lighting.
- The bending machine may not be modified in its design
and may not be used for purposes other than those fo
-
reseen by the manufacturer.
- Never work under the influence of concentration-distur
-
bing illnesses, fatigue, drugs, alcohol or medicines.
- Keep children and persons not familiar with the Plate
rolling machine away from their work environment.
- Do not pull on the mains lead to pull the plug out of the
socket. Protect the cable from heat, oil and sharp
edges.
- Eliminate disturbances that affect safety immediately.
- Protect the round bending machine from moisture.
- Make sure that no parts are damaged before using the
plate rolling machine. Damaged parts must be replaced
immediately to avoid danger sources.
- Do not overload the bending machine! You work better
and safer in the specified performance range. Use the
right tool! Make sure the tools are not dull or damaged.
- Only use original spare parts and accessories to avoid
possible risks and risks of accidents.
2.5 Safety labels on the Plate rolling machine
The plate rolling machine has various warning labels and
safety markings that must be observed and followed.
The safety markings attached to the plate rolling ma
-
chine must not be removed. Damaged or missing safety
markings can lead to malfunctions, personal injury and
material damage. They are to be replaced immediately.
If the safety markings are not immediately recognizable
and comprehensible, the round bending machine should
be taken out of operation until new safety markings have
been made.
Fig. 1: Safety labels
3
Intended use
The round bending machine RBM 305 is used exclusi
-
vely for the production of round shaped parts such as pi
-
pes, cones, cylinders, wires etc. with a maximum width
of 305 mm.
The material must consist of sheets of steel and other
metallic materials, as well as materials which are
suitable for processing because of their plastic deforma
-
bility. Editing brittle and brittle materials is prohibited.
The material to be bent must not exceed the maximum
sheet thickness specified for the machine. The work
-
pieces must be in the form of sheet metal or flat profiles
so that they can be safely captured and transported by
the rollers. The machine may only be operated by a
single person who has been instructed in the use and
maintenance of the machine.
Safety boots
Safety boots protect the feet from being crushed, fall
-
ing parts and slipping over on slippery ground.
Protective clothes
Protective clothes are made of a tightly fitted fabric
without the protruding parts of low tear strength.
1
2
3
4
5
