6
RBM 305 | Version 2.02
Technical Data
Proper use also includes compliance with all information
in this manual. Any use beyond the intended use or
otherwise is considered misuse.
3.1 Unintended use
By observing the intended use, no reasonably fore
-
seeable misuse is possible, which could lead to dange
-
rous situations with personal injury.
3.2 Residual risks
Even if all safety instructions are observed, and the ma
-
chine is put to its intended use, there are still residual
risks, which are listed below:
- There is a risk of injury to the upper limbs (e.g., hands,
fingers).
- Danger from falling workpieces
- Danger from the ingress of clothing and objects.
- During set-up and set-up work, it may be necessary to
dismantle on-site protective equipment. This creates
various residual risks and potential dangers that every
operator must be aware of.
4
Technical Data
* Bending power ratings refer to S235JR with a tensile strength of 400
N / mm2
* Sheet bending capacity in VA = factor 0.75; Conical bending with half
of the max. Sheet thickness possible
Fig. 2: Diagram for yield points
5
Transport, packaging, storage
5.1 Transport
Check the Plate rolling Machine on delivery for any visi
-
ble transportation damage. If you notice any damage to
the device please report this immediately to the carrier or
dealer.
5.2 Packaging
All used packaging materials and packaging aids are re
-
cyclable and should be taken to a materials recycling de
-
pot to be disposed of.
The delivery packaging is made of cardboard, so please
dispose carefully by having it chopped up and given to
the recycling collection
The film is made of polyethylene (PE) and the cushioned
parts of polystyrene (PS). Deliver these substances to a
collection point for recyclable materials or to the waste
disposal company which looks after your region.
5.3
Storage
Store the Plate rolling Machine thoroughly cleaned in a
dry, clean and frost-free environment. It must not be shut
down with chemicals in a room. If the machine is stored
for a long time, all bare metal parts must be greased
against rusting.
WARNING!
Dangers in case of unintended use!
Misuse of the bending machine can lead to dange
-
rous situations.
- Only operate the bender in the power range speci
-
fied in the technical data.
- Never bypass or override the safety devices.
- Only operate the round bending machine in a tech
-
nically perfect condition.
Type
RBM 305
Max. working width
305 mm
Roller Ø
25 mm
Longitudinal grooves in
diameter
4/6/8 mm
Dimensions L x B x H
580 x 210 x 255 mm
Weight
14 kg
Max. sheet thickness
0,8 mm
Bending Ø min.
40 mm
WARNING!
Danger to life!
The packaging elements may pose potential hazards
(e.g., plastic bags):
- Packaging material for children and persons
who are unaware of their actions or keep ani
-
mals inaccessible.
