Safety
03.05.2018
page 8
Safety Plate rolling machine RBM 610-8 ; Version 1.05
©
20
18
GB
Only authorized persons are allowed to work on the bending machine!
Authorized persons for the operation and maintenance are the instructed and trained specialists
of the operator and the manufacturer.
The operator must
Obligations
of the opera-
tor
train the staff,
instruct the staff at regular intervals (at least once a year) about
all safety regulations concerning the machine,
the operation,
the accepted rules of technology,
check the level of knowledge of the staff,
document the training / instruction,
have the participation in the training / instruction confirmed by signature,
Check whether the staff works safety-conscious and follows the operating instructions.
The operator has to
Obligations
of the opera-
tor
- have received training in handling the bending machine
- know the function and mode of action,
- before commissioning
- have read and understood the operating instructions
- be familiar with all safety devices and regulations.
1.5
Operator positions
The operator position is in front of the bender.
1.6
Safety equipment
Operate the bender only with properly functioning safety devices. Stop the bender immediately if
a safety device is faulty or becomes ineffective. You are responsible! After the response or the
failure of a safety device, you must not use the bender again until you have
have eliminated the cause of the disorder,
have convinced themselves that this creates no danger to persons or property
WARNING!
If you bypass, remove or otherwise disable a safety device, you endanger yourself and
other people working on the bending machine. Possible consequences are
• Injuries from flung-off workpieces or workpiece parts,
• touching rotating parts.
The round bending machine has the following safety features:
Protective cover of the gearbox.
a safety rope
1.7
Security check
Check the bending machine before each new start or at least once per shift. Immediately report
damage or defects and changes in operating behavior to the responsible manager.
Check all safety devices
at the beginning of each shift (in interrupted operation),
once a week (during continuous operation),
