6
UB 10 | Version 2.01
Technical Data
3.1 Misuse
If the intended use is observed, no reasonably foresee
-
able misuse is possible, which could lead to dangerous
situations with personal injury.
3.2 Residual risks
Even if all safety regulations are observed and the ma
-
chine is used correctly, there are still residual risks listed
below:
- There is a risk of injury to the upper limbs (e.g., hands, fin
-
gers).
- Danger from falling workpieces
- Danger of pulling in clothes and objects.
- During set-up and set-up work, it may be necessary to dis
-
mantle on-site protective equipment. This creates various
residual risks and potential dangers that every operator
must be aware of.
3.3 Technical condition
The Universal Bending Machine UB 10 complies with the
current state of the art in design and execution and is
built according to the recognized safety rules.
Please note the following:
- Before each use, the machine should be checked
for externally visible damage.
- During each use, the operating behavior is obser
-
ved.
- In the event of safety-relevant deviations from the
delivery condition, the machine must be inspected by
an authorized specialist and, if necessary, repaired.
- From the point in time when the machine no longer
meets the normal operating conditions, the bending
machine must be taken out of service until repaired.
3.3.1 Machine operation
The bending machine can be dangerous if it is not used
in accordance with the chess and intended purpose.
In addition to the health and safety instructions in this
operating manual, the generally applicable safety and
accident prevention regulations for protection against the
risk of injury must be observed and adhered to.The work
instructions in the individual chapters of the operating in
-
structions must be followed. The safety instructions must
be observed under all circumstances. Despite observing
all working instructions, safety and accident prevention
regulations, there remains a residual risk when handling
the machine. Through concentrated and forward-looking
work and action, you can reduce the residual risk.
4
Technical Data
Scope of delivery:
- Bending rollers: 2 x Ø 24/30/37/43/49/62/75 mm
Optional accessories:
- Heating pipe bending roller set
Item number:
3790001
- Bending roller set 10-180
Item number:
3790002
- Adjustable stop 10-200
Item number:
3790003
- Clamping plate
Item number:
3790004
- Conversion kit for UB 10 to RB 30
Item number:
3790006
- Helical bending element UB 11
Item number:
3790011
- Separate holding handle for helical bending element UB 11
Item number:
3790280
DANGER!
The machine may only be operated in a technically
perfect condition. Any faults must be eliminated im
-
mediately.
DANGER!
Unauthorized modifications or changes, especially
those that affect the safety of the machine operator,
are generally prohibited. Technical changes, conver
-
sions and extensions made by the user on the ma
-
chine may void the machine's operating license and
are the responsibility of the operator.
ATTENTION!
In the interest of further technical development or
changing regulations, the manufacturer reserves the
right to make changes to the characteristics of the
product at any time without prior notice.
Technical Data
UB 10
Pipes
G 3/4 "
Weight
32 kg
Flat steel: plate rolling
10 x 50 mm
Flat steel: acute bending
6 x 50 mm
Round materials Steel/Aluminium/Copper
16 mm
Round materials stainless steel
14 mm
Square materials Steel/Aluminium/Copper
16 x 16 mm
Square materials stainless steel
14 x 14 mm
