Work and operation
UB 10 | Version 2.01
9
Fig. 5: Centering the counter-holder
In most cases it is not necessary to use a retaining clip
when using an anvil. However, you can use a holder
clamp, if you want to make special curvatures.
Fig. 6: Right Position of the counterholder
Examples of the eccentric counterhold for each "correct"
position:
Position 1
Bender for flat material or round material of 6 mm: Ø
37 m
Fig. 7: Example Position 1
Position 2
Bender for flat material or round material of 6 mm: Ø
75 mm
Fig. 8: Example Position 2
Position 3
Flat or round material of 6 mm: use central bolt
Fig. 9: Example Position 3