15
OPERATION MANUAL
4. COMMISSIONING
4.1. PREPARATION OF THE MACHINE.
q
Remove all wrapping and packing grease from the machine.
q
Check the machine for loose bolts. Tighten as required.
q
Inspect for oil leakage or loose fittings. Similarly check the main rams between the top frames.
q
Clean the blades and tighten the securing bolts as required. Examine the cutting edges of both
blades for damage.
q
Inform your service provider of any damage or faults with the machine.
Warning- Follow all setup instructions before starting hydraulic pump.
The safety circuit consists of a reset switch and two rear side guards, each having 3 sensors. Your ma-
chine may or may not have a RED warning light. If there is no red warning light, then see the NC89
for display (Reset Rear Guard). When the main power is switched on or the rear sensors have been
tripped the safety circuit must be reset before the hydraulic pump can be started.
Warning Indication: The safety circuit has not been Reset.
4.2 OMROM E3Z SAFETY SENSOR ALIGNMENT
Red Warning Light
or
Reset Switch
Press to reset safety circuit and then press OK on NC89.
Page 15
Instructions Manual for HG-4012 (S948)
12/02/2018
