16
OPERATION MANUAL
4.2 OMROM E3Z SAFETY SENSOR ALIGNMENT. CONT.
Identifying Sensors
Sender
The sender has one red light on top of the unit and one red light
at the front. These two lights will be on all the time while the
machine has power.
Receiver
The receiver has two lights on top of the unit. The receiver should have one green light on or a red
and green light on when all the sensors have been aligned correctly.
Note: No.1 receiver could be mounted top, middle or bottom on the guard.
The receivers are wired in series so No.1 receiver will have a green light on, indicating it has power.
When it is correctly aligned with its sender the red & green light will be on and it will send power
to No.2 receiver.
No.2 receiver will have a green light on and when that receiver has been correctly aligned with its
sender the red & green light will be on and it will send power to the No.3 receiver.
No.3 receiver is aligned using the same technique.
So when all 3 receivers are aligned correctly with their corresponding senders they should all have
red and green lights on top of each unit.
Identifying Sensors
Page 16
Instructions Manual for HG-4012 (S948)
12/02/2018
