7
OPERATION MANUAL
SAFETY CHECKS BEFORE OPERATING
q
Ensure fixed guards are in place to prevent hands or other parts of the body from entering
area’s of high risk
q
Guards or safety devices must never be removed or adjusted, except by an authorized person
for maintenance purposes.
q
Working parts should be well lubricated and free of rust and dirt.
q
The area around the machine must be adequately lit and kept free of materials, which might
cause slips or trips.
q
Be aware of other personnel in the immediate vicinity and ensure the area is clear before using
equipment.
q
Familiarize yourself with and check all machine operations and controls.
q
Ensure cutting table is clear of scrap and tools.
q
Faulty equipment must not be used. Immediately report suspect machinery
SAFETY CHECKS WHEN OPERATING
q
Do not attempt to cut material beyond the capacity of the machine.
q
Never attempt to cut rod, strap or wire with this machine.
q
Use correct lifting procedures when handling large sheets of material.
q
Take extreme care during the initial feeding of the workpiece into the machine.
q
The workpiece should always be held sufficiently far back from the edge being fed into the
guillotine.
q
Ensure fingers and limbs are clear before operating the guillotine.
q
Hold material firmly to prevent inaccurate cutting due to creep.
q
When cutting ensure feet are positioned to avoid contact with the foot operated lever.
SAFETY CHECKS AFTER OPERATION
q
Remove all off cuts and place them in either the storage rack or waste bin.
q
Leave the work area in a safe, clean and tidy state.
POTENTIAL HAZARDS
q
Cuts from the sharp edges and burrs on the sheets before and after cutting
q
Parts of the body being caught in crush and pinch points.
q
Injuries caused when handling metal sheets
Page 7
Instructions Manual for HG-4012 (S948)
12/02/2018
