8
OPERATION MANUAL
The electrical and hydraulic circuits of your machine are designed to allow operation with maxi-
mum safety. The following precautions are available on the machine for enhanced safety.
There are four Emergency stop buttons (engaging type) on the machine. Two are found on the
front of the machine, one on the foot switch control unit, and one on the main control unit. Once
the button has been pressed to reset the emergency stop, the red button must be rotated to reset
the stop.
2.2. SAFETY FEATURES OF THE MACHINE:
Foot pedal control
Emergency stop button (engaging type) is available on the foot switch control unit.
The foot pedal when pressed activates the shearing beam and must be held in the
depressed position until the machine has completed its cut.
Releasing the foot pedal during the shearing operation will return the machine to
the top of its stroke when controller is set to single cut.
Main Controls
The main machine operating controls are located on the pendant.
1
2
3
4
8
5
6
7
1 Continuous or Single Cut
5 Power On Indicator Light
2 Rear Guard Sensor Light
6 Illumimated Pump Start Button
3 Shadow Line Light ON/OFF
7 Hydraulic Pump Stop
4 Power ON/OFF to Controller
8 Emergency Stop
Page 8
Instructions Manual for HG-4012 (S948)
12/02/2018
