16
OPERATION MANUAL
4. COMMISSIONING
4.1. PREPARATION OF THE MACHINE
q
Remove all wrapping and packing grease from the machine.
q
Check the machine for loose bolts. Tighten as required.
q
Inspect for oil leakage or loose fittings. Similarly check the main rams between the frames.
q
Clean the blades and tighten the securing bolts as required. Examine the cutting edges of
both blades for damage.
q
Inform your service provider of any damage or faults with the machine.
Warning-
Follow all setup instructions before starting the
hydraulic pump.
The safety circuit consists of a reset button and two rear side
guards, each having 3 sensors. The machine has a RED warning
light mounted on the control panel when the circuit has been
tripped.. (Fig.4.1) When the main power is switched on or the
rear sensors have been tripped, the safety circuit must be reset
before the hydraulic pump can be started.
F
ig
. 4.1
Reset Button
The reset button is mounted on the rear of the control panel
under the isolating switch. Press to reset the safety circuit
(Fig.4.2)
4.2 SAFETY SENSOR ALIGNMENT
F
ig
. 4.2
22/07/2019
Instructions Manual for SG-420 (S535)
16
