20
OPERATION MANUAL
4.4 COMMISSIONING CHECK LIST.
Before starting the machine the following checks must be carried out.
q
Installation and machine preparation has been performed according to the instructions in
this manual.
q
Fill the oil reservoir with
46
grade hydraulic oil and ensure that the oil filter breather cap is
fitted
q
All grease nipple points have been lubricated.
q
Electrical earth fitted and power circuits, switches, and foot-pedal have been checked.
q
Check power connections and any damage to any wiring.
q
Setup rear sensors
q
Test safety operation, Emergency stop, rear sensors, stop button etc.
q
Test cut material and check quality of cut
q
Tools, equipment and personnel are clear of the machine.
q
Operation Manual on how to operate the machine has been read.
5. OPERATION INSTRUCTIONS
5.1 PRE-OPERATIONAL SAFETY CHECK PRIOR TO OPERATING
Before operating the machine the rear safety beam guard
needs to be checked.
Below are the steps that need to be followed.
1. Start the machine as per the instruction procedures
2. Stand outside the rear safety gate & obstruct sensor (1)
3. Ensure the machine has stopped and is disabled
4. Check your control panel warning light is illuminated.
(Fig. 5.1)
5. Press the green reset button on the rear of the electrical box
(Fig. 5.2)
6. Press the Hydraulic pump start button on the control panel
to activate the operational system. (Fig. 5.3)
7. Repeat steps 1 to 6 for each sensor (2) & (3)
F
ig
. 5.1
F
ig
. 5.2
F
ig
. 5.3
22/07/2019
Instructions Manual for SG-420 (S535)
20
