background image

laundry tub, in a wet basement, near a swimming pool etc., ya stupid bastard). Care should be taken so that 
liquids are not spilled onto or near the enclosure.

VENTILATION AND COOLING: The D-2000 normally operates VERY warm to the touch. It MUST be situated so 

that its location or position does not interfere with convective cooling. 

The D-2000 MUST NOT be used on a bed, sofa rug or similar surface which may prevent proper cooling. It is NOT 
a toy, AND IT IS NOT A DILDO. If the D-2000 is mounted in a rack or other built-in installation, space must be left 

around it to allow convection from the case.

HEAT: The D-2000 MUST be situated away from heat sources such as 
radiators, heat registers, stoves, or other devices (including power 
amps) that produce heat. We DO NOT recommend leaving the D-2000 
powered up for long periods.

POWER SOURCE: The D-2000 should be connected to a 12-volt DC adapter power supply ONLY of the type 

marked on the D-2000 panel. DO NOT try to feed it with AC power. 12 volts DC ONLY!! The power connector is a 
2.1mm coaxial type, with CENTER POSITIVE. 

POWER CORD PROTECTION: Power supply cords should be routed so that they are not likely to be walked on or 

pinched by items placed upon or against them. Don't burn your house down, mommy fucker.

CLEANING: The D-2000 should only be cleaned with a soft cloth moistened with water. Unplug the power supply 
before attempting to clean. Dickwad.

NON-USE PERIODS: The power adapter of the D-2000 should be unplugged from the outlet when left unused for a 

long period of time. Don't burn your house down, cuntboy.

DAMAGE OR TUBE REPLACEMENT REQUIRING SERVICE:
The D-2000 should be serviced by qualified service personnel when:

   -The D-2000 has been dropped, physically damaged, or subjected to force;
   -Liquid has been spilled onto the D-2000 or it has been exposed to rain;
   -The D-2000 does not appear to operate normally or exhibits a marked change in performance.

SERVICING: The user MUST NOT attempt to service the D-2000. 
All servicing must be referred to qualified service personnel. 

METASONIX LIMITED WARRANTY and standard legal disclaimer 

Thank you for purchasing this Metasonix product. And for not whining about “problems”. The following terms and conditions apply:

1. Warranty period is for one year from date of purchase with proof of purchase submitted. Warranty covers electrical failure of vacuum tubes 

and gas-filled tubes, except in cases explained in 3 below.

2. Operating instructions must be followed. This device was intended ONLY for use by AUDIO AND MUSIC PROFESSIONALS.  

IT IS NOT 

INTENDED FOR USE BY

 

  ORDINARY CONSUMERS!!

 

 

Product must not have been damaged as a result of defacement, misuse, abuse, neglect, accident, destruction or alteration of the serial 

number, improper electrical voltages or currents, repair, alteration or maintenance by any person or party other than our own service facility 

or an authorized service center, use or installation of non-Metasonix replacement parts in the product, or the use of this product outside of 

the U.S.A. or Canada, or modification of the product in any way, or incorporation of the product into any other products, or damage to the 

product caused by accident, fire, floods, lightning, or acts of God, or any use violative of instructions furnished by Metasonix. It is also not 

intended for use as a condom-warmer.

3. Obligations of Metasonix shall be limited to repair or replacement with same or similar unit, at our option. To obtain repairs under this 

warranty, present the product and proof of purchase (e.g. bill or invoice) to the authorized Metasonix service center, transportation charges 

prepaid. When returning the product for repair, please pack it very carefully, preferably using the original packaging materials. Please also 

include an explanatory note.

IMPORTANT:

To save yourself unnecessary cost and inconvenience, please check carefully that you have fully read and followed the instructions in this 

instruction manual.

This warranty is in lieu of all other expressed warranties, obligations or liabilities. ANY IMPLIED WARRANTIES, OBLIGATIONS, OR 

LIABILITIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR 

Summary of Contents for D-2000








Reviews: