9
Care and maintenance
| EN
6.3.
Setting the dosage
1
To change the dosage, fi rst remove the pump from the dispenser (see
„6.2. Pump removal / pump replacement“).
2
The dosage can be changed to 1.5 m (MAX) / 1.0 ml / 0.75 ml (MIN)
(dosage dependent on the viscosity of the fi lling solution) by turning the
adjustable wheel.
With fi rst use, the wheel may be hard to turn; if necessary use a pair of
fl at-nose pliers.
CAUTION:
Do not dismantle the housing! Use only original spare parts. The dispenser is only suitable for
dispensing compatible products such as liquid soap (without abrasives), low viscosity lotions or
disinfectants.
ATTENTION:
The use of incompatible products can impair the function of the dispenser and may cause liquid
to spray into eyes!
7. Care and maintenance
7.1.
General care instructions
The Robert Koch-Institute recommends: “For both dispenser types (note: hand disinfectant and soap dispenser), the fi xed
outer and inner parts must be able to be reprocessed. This is also possible by machine. (...) Visible contamination of the
outer housing and all accessible parts without further manipulation as well as soilings at the outlet must be removed by
wipe disinfection. Daily wipe disinfection is recommended for operating levers. The scope and frequency of checks and
the reprocessing of dispensers should be specifi ed in the internal hygiene plan, e.g. every six months.” (Source: Robert
Koch Institute, recommendations for hand hygiene, 2016)
In order to guarantee proper functioning of the dispenser regular manual cleaning is necessary.
