50
Calibrating the Miter Table Indicator
After checking or adjusting the fence to confirm
that it is at 90ºto the Blade, check the accuracy
of the Miter Table Angle Indicator.
1. Loosen the screw holding the Angle
Indicator in place.
2. Rotate it until the pointer is exactly on 90º
3. Retighten the screw.
Calibrating the Bevel Angle
For making accurate cuts, the Saw Blade must
be adjusted to be exactly vertical to the Table.
1. To check the angle, have the blade
assembly in its normal upright position.
Make a cut on a piece of flat sided, fairly
thick scrap material.
2. Check the cut with an accurate square.
The cut should be at exactly 90º
3. Angle can also be checked by rotating
one cut_off piece 180ºand holding
the cut ends together. If the cut is not
exactly vertical, the two pieces will form a
slight angle.
4. If necessary, the bevel angle can be
corrected by adjusting the Bevel
Adjustment Screw on the right side under
the Bevel Locking Lever.
5. Once the bevel angle is adjusted, adjust
the Bevel Angle Indicator to read 0ºwhen
the Saw Blade is in the vertical position.
Loosen the screw holding the Indicator in
place, adjust it to be exactly over the
0ºmark, then retighten the screw.
Adjusting or Replacing the Kerf Board
If the Kerf Board becomes damaged it must be
replaced.
1. Remove the four screws holding the Kerf
Board in place.
2. Install a new Kerf Board. Replace the four
screws and tighten them slightly.
To adjust the Kerf Board:
1. Lower the Saw Blade and lock it down
with the Locking Pin.
2. Adjust the Kerf Board so the right side of
the Blade slightly clears the edge of the
Kerf Board.
3. Loosen the Bevel Lock and set the Bevel
Angle at 45ºleft.
4. Ensure that the left side of the Blade
clears the Kerf Board.
5. Tighten the four screws holding the Kerf
Board in place.
