38
Note: When inclining saw blade, lift up the handle.
FIXATION DE L
’
OUVRAGE
FIXING WORKPIECE
Warning: Must fix workpiece correctly and firmly
with vice otherwise the tool and workpiece will be
damaged and user may injure. After finishing cut,
wait until saw blade stop rotation then lift it up.
Mount the vice on side of the hold of guide plate and
fix the screw at back of the plate to fix lever of vice.
Adjust position of vice bracket according to
workpiece thickness and shape.
Note: During operation, workpiece should be fixed
firmly by a vice and against the rotative base and
guide plate . If some parts touch the vice, readjust
the position of vice bracket. Place workpiece against
the guide plate and rotative base. Put workpiece to
the cutting position and tighten screw at vice to fix
workpiece firmly.
Note: When cutting long workpiece, use support
which is as high as upper surface of rotative base.
OPERATION
NOTE:
●
●
●
●
Before use, saw head must be released from
locked to operating position, DO NOT operate
saw in lower locked position.
●
●
●
●
Before turning on, confirm that saw blade will
not contact wood or any other surface.
●
●
●
●
When
cutting,
use
moderate
downward
pressure, DO NOT force the saw.
●
●
●
●
When cutting, lower handle slowly
PRESSED CUTTING (cut small workpiece)
Workpiece within 60 mm height, 120 mm width can
be cut as following method.
●
●
●
●
Fix workpiece with vice.
●
●
●
●
Turn on the switch and wait till the saw blade
reaches max. Speed, then
lower the saw blade gently to cut .
●
●
●
●
When finished a job, turn off the switch .
●
●
●
●
Don
′
t lift up saw blade until it stops completely.
MITERED ANGLE CUT
Please refer to the above section “ADJUSTMENT
OF MITERED ANGLE”.
BEVEL CUT
●
●
●
●
Can make left bevel cut form 0°to 45°.When
bevel angle is 45° it can cut 28mmX120mm
workpiece.
●
●
●
●
Loosen lever and incline saw blade to set the
angle. Fix workpiece with vice.
●
●
●
●
Turn on the switch and make sure that saw
blade has attained full-speed revolution. Lower
handle to the end gently to cut workpiece.
●
●
●
●
After finished with a job, turn off the switch. Lift
up saw blade completely after it stops rotation.
Needle indicator
