25
A01-00055 Rev M
NOTE:
You may, of course, connect your computer to the UPM without
using software. When power is lost, the UPM will beep and you will
have to manually shut down the computer and UPM.
Start Manager
When AC power is not available, such as in a new installation where
wiring may be incomplete, you can still start the UPM to test its operation
and the operation of your system using Start Manager. With the UPM off,
follow these simple steps:
1. Disconnect the input AC power cable from the AC mains.
2. Ensure that the batteries are connected behind the front panel.
3. Press and hold the On/Off switch on the front panel until the
UPM beeps.
4.
The UPM is now running on battery. When you have finished,
press the On/Off switch again. Plug the input AC power cable
into the rear panel of the UPM.