blue’Log X series
15| 52
5.3
Installation
5.3.1
Installing device on DIN rail
1.
Hang the blue’Log on the top-hat rail using the clamping fixture (rear panel).
2.
Move the DIN rail slider
situated on the front panel from bottom (latch open) to
top (latch closed) position. This will fix the blue’Log to the DIN rail. The symbols
(open/closed lock) above and below the slider indicate the current status of the
fixation.
3.
Check that the blue’Log is securely fastened to the DIN rail.
Fig. 3: Secure mounting on a DIN rail
To release the blue’Log from the DIN rail, move the slider down again. The device can
now be removed from the DIN rail securely.
ATTENTION
Ventilation
For installation in a control cabinet, ensure at least 3 cm of space above and
below the device for air circulation.
Summary of Contents for blue'Log X Series
Page 1: ...blue Log X series X 1000 X 3000 Operating manual Version 20150201...
Page 54: ...52 52 blue Log X series...
Page 55: ......