blue’Log X series
31| 52
7.7
Logger basic data
The basic data of the data logger are displayed or can be changed in this menu
“Logger Basic-Data”. To enter this menu, follow these steps:
1.
Navigate to the "System" area via the top navigation bar.
2.
Navigate to the "Basemodule" area via the left-hand navigation menu and click on
"Logger basic data".
3.
The following information is displayed:
Model
(of the blue’Log, e.g. X-1000)
Serial number
(of the blue’Log, 79810X XXXX XXXX)
System ID
(from the portal, five characters)
4.
The following settings can be made:
Data logger name
(Name describing your system)
Data recording interval
(interval at which the measurement data are saved in the database. Five-minute
and 15-minute values can be selected. Fifteen-minute values are recommended
for the longest possible storage time.)
7.8
Ethernet
In the "Ethernet" menu all network settings from Chapter 7.5 also can be made.
1.
Navigate to the "System" area via the top navigation bar.
2.
Navigate to the "Basic module" area via the left-hand navigation menu and click on
"Ethernet".
The following network settings can be made:
Enable DHCP
IP address
Subnet mask
Standard gateway
Obtain automatic DNS address (on / off)
First DNS server
Second DNS server
Summary of Contents for blue'Log X Series
Page 1: ...blue Log X series X 1000 X 3000 Operating manual Version 20150201...
Page 54: ...52 52 blue Log X series...
Page 55: ......
