44 | 120
blue’Log X series
3.
Via the drop-down menu, select a sensor model you connected to the input of the
blue’Log data logger (e.g. Si
-12TC-T). After selection the entry menu expands with
further settings for this sensor.
4.
If the sensor to be connected is not included in the list, you can select a generic
template and configure the sensor manually. Please check in the data sheet
whether the sensor is compatible.
5.
Choose a "device name" which clearly identifies the sensor.
6.
Via the drop-down menu, select one of the four ports (MI-1 to 4) to which the
sensor is connected. If you have expanded y
our blue’Log basic device using a multi
I/O MX module, further ports will be available.
7.
The following suggested parameters can be carried over unchanged:
Unit
Gradient
Offset
8.
Pay attention to the tabs under Device configuration. Each possible sensor
measurement is configured in a separate tab (see Fig. 25: Irradiance tab and
Temperature tab).
9.
By selecting "Save", the sensor will be recorded and listed in the "Sensor overview".
Fig. 26: Device websites: Sensor overview
–
analog sensors
