blue’Log X series
9 | 120
3.
Safety instructions for operation
3.1
Intended use
Only the permitted signals and signal strengths may be applied to the connections of
the data logger (blue’Log) and the expansion modules (MX modules)
used here.
Installation is only permitted indoors. For installation outdoors or in a dusty
environment, the device must be installed in a standardized protective enclosure.
3.2
Personnel
Installation, commissioning and maintenance of the device may only be performed by a
qualified electrician.
Given their specialist training, knowledge, experience and familiarity with the relevant
standards and regulations, a qualified electrician is in a position not only to carry out
work on electrical systems but also to recognize and avoid possible dangers unaided.
The qualified electrician must comply with the occupational health and safety laws in
force.
Please note in particular:
all national installation and set-up regulations (e.g. VDE in Germany),
all generally accepted codes of practice,
information on transport, installation, operation, service, maintenance and disposal
given in this installation manual,
specific values, limits, and information relating to operating and ambient conditions
on type plates and in data sheets.
