blue’Log X series
17 | 120
5.3
Installation
5.3.1
Installing device on DIN rail
1.
Hang the blue’Log on the DIN rail using the
provided clamp (rear panel).
2.
Push the DIN rail latch
on the front side of the device from bottom (latch open)
to top (latch cl
osed). This will fix the blue’Log to the DIN rail. The symbols
(open/closed lock) above and below the DIN rail latch indicate whether or not the
device is fixed.
3.
Check the secure connection of the
blue’Log to the DIN rail.
Fig. 3: Secure mounting on a DIN rail
To release the blue’Log from the DIN rail, push the DIN rail latch from
top to bottom
position. The device can now be removed from the DIN rail by lifting it off.
ATTENTION
Ventilation
For installation within a control cabinet, ensure at least 3 cm free space
above and below the device for air circulation.
