blue’Log X series
45 | 120
10.1.2
Modbus sensors
1.
Navigate to the "Devices" area via the top navigation bar.
2.
Navigate to the "Sensors" area via the left-hand navigation menu.
Fig. 27: Device websites: Adding new modbus sensor
3.
Via the drop-down menu, select a sensor model connected to the input of the
blue’Log data logger (e.g. ST
-RS485-TC-T). After selection the entry menu expands
with further settings.
4.
Choose a "device name" which clearly identifies the sensor.
5.
Via the drop-down menu, select one of the two ports (RS485-1 or
RS485-2) to which you have connected the sensor. If you have expanded your
blue’Log basic device using an RS485/422 MX module, further ports will be
available.
