User Manual
MOD3CT
000000
.
40
000000
.
40
000000
.
40
id 01
sl 0000
sH 0000
IMP
EXP
Kvarh
kWh
IMP
EXP
Kvarh
kWh
IMP
EXP
Kvarh
kWh
Hz
Kvar
KWA
Hz
Kvar
KVA
Hz
Kvar
KVA
ID Address
Serial number
(high digit)
Serial number
(low digit)
Communication
Display (flashing)
II
I I
I I
I
I
I
I
I
I
I
I
I
I
I
I
I III
ll l
l
l
l
l
l
l
l
l
l
l
l ll
888888
.
8
.
8
L1 59
.
6
MP
EXP
Kvarh
kWh
Hz
Kvar
KW
A
will flash to indicate that the value of
current is negative
888888
.
40
L3 0
MP
EXP
Kvarh
kWh
Hz
Kvar
K A
V
will flash to indicate that the value of
display is zero
l
l l
l
l
l
l
l
l
l
l
l
l
l ll
It is used as recording consumption and can’t be reset to zero. The reading accuracy is 1/100 kWh.
Button operation:
Right button is selection , left button is program .
Button selection : one short press, lighting the backlight, then press one time show one parameter,
the order is as following: voltage of one phase, current of one phase, active power, reactive power, frequency, baud rate,
ID address, serial number, in total 13 parameters, after one minute the backlight will close automatically.
Press left button more than 3 seconds enter in code confirmation process, use right button choose the
code number then use left button change the digit place, when finish code entering use left button press more than 3 seconds
for confirmation then display show ID 01, use left button to change the display item, use right button to change the information.
The items can be settled is : 1: ID; 2: baud rate, 3: number of display item (The number of Phase voltage, phase current,
active power, reactive power, frequency, communication baud rate, ID address, serial number), 4 CT ratio setting for CT
connection meter.
Pulse output
The MOD3CT Series DIN rail energy meter is equipped with a pulse output which is fully separated from the inside circuit.
That generates pulses in proportion to the measured energy for accuracy testing.
