|
23
EDITION 002 2124
METOS PROXY ELECTRIC RANGES
Residual risk
There are risks on the machine that have not been completely eliminated from a design standpoint or with the
installation of adequate protection devices.
To provide the Customer with full information, given below are the residual risks that remain on the machine:
such actions are deemed improper and therefore strictly forbidden.
RESIDUAL RISK
HAZARDOUS SITUATION
WARNING
Slipping or falling
The operator may slip due to water or dirt
RQWKHÀRRU
When using the equipment, use individual
antislip protective devices.
Burn
The operator intentionally touches parts of
the equipment.
When using the equipment, use individual
heat protection devices.
Burn
The operator intentionally touches hot
cooking substances (oil, water, steam, etc.).
When using the equipment, use individual
heat protection devices.
Electric Shock
(Electrocution)
Contact with live electrical parts during
maintenance operations carried out with the
electric panel powered. The operator
intervenes (with an electric tool or without
disconnecting the power) lying on the wet
ÀRRU
Maintenance of the equipment must only be
FDUULHGRXWE\TXDOL¿HGSHUVRQQHOSURYLGHG
with personal protective devices against
electrocution.
Electric Shock
(Electrocution)
Electrocution caused by malfunction of the
grounding system or electrical protection
devices.
Install protection devices complying with
applicable regulatory requirements
upstream of the equipment.
Falling from above
The operator intervenes on the machine
using unsuitable systems to access the top
part (e.g. ladders or climbs on it).
Do not intervene on the machine using
unsuitable systems to access the top part
(e.g. ladders or climbing on it).
Overturning of loads
Handling of the equipment or part of it
without suitable means.
Use suitable lifting systems or accessories
when handling the equipment or packaging.
Chemical
The operator comes into contact with
chemicals (e.g. detergent, scale remover,
etc.)
Use appropriate safety measures. Always
refer to the safety data sheets and labeling
of the product used.
Use the Personal Protective Equipment
recommended in the safety data sheets.
Cuts
Risk of cuts on the internal parts of the
machine frame during maintenance.
Maintenance must only be carried out by
TXDOL¿HGSHUVRQQHOSURYLGHGZLWKSHUVRQDO
protective equipment (cut-resistant gloves
and garments covering the forearm).
Crushing
7KH¿QJHUVKDQGVRISHUVRQQHOFDQEH
crushed when handling movable parts.
Maintenance must only be carried out by
TXDOL¿HGSHUVRQQHOSURYLGHGZLWKSHUVRQDO
protective equipment (gloves).
Ergonomics
The operator intervenes on the appliance
without the necessary personal protective
equipment.
The operator must intervene on the
equipment provided with Personal
Protective Equipment.
Summary of Contents for 712ECTPT
Page 28: ...www metos com...
