8.4.2016
METOS Ardox IEC
12
|
5.5. Electrical connections
Check and ensure that supply voltage is the same as the voltage given on the rating plate of the appli-
ance.
The electrical connections must satisfy local house installation regulations. The valid national and local
regulations of the electricity-supply inspection must be observed.
To make eventual future service easier and increase safety, a mains switch must be installed near the
appliance. This switch must disconnect the appliance completely from an electrical supply network.
The feed-through for the supply cable is located at the bottom of the range in the right front corner. To
connect the supply cable to the terminal, do the following:
• Open ceramic hob and fix it by the fixing rod. The fixing rod is on the left side inside the enclosure
• Connect supply cable to the terminal. The terminal is on the right side inside the enclosure
• To assemble appliance, carry out operations described above in opposite order
Before close the ceramic hob, check that no wires inside the range get jammed.
5.6. Test-run
Please read the user manual before testing the appliance. After connecting the supply cable, check the
function of the range.
Use cookware suitable for induction cooking. Diameter of the bottom of cookware should be at least
120 mm.
• Put some water inside cookware and place the latter in the centre of selected cooking zone
• Turn corresponding knob from “0”position to any position between “1” and “12.” Green indicator LED
above the knob will be active and water will be heated
• Take cookware away from cooking zone, indicator light will be flashing
• Place cookware back on the heating area, indicator light will be active again and heating process will
be continued
• Adjust to maximum power.
• After a few minutes the fan must switch on.
• Turn the knob to “0”position. Heating will be stopped and indicator light will be off
STOP
