3
Installation Instructions
INSTALLATION
-
The machine is supplied factory lubricated and ready to run. It should be positioned on
any solid, level and non-skid work surface that is nonflammable. Install in work area with
adequate light and space.
-
For Model JET-20I, you may place the mixer on bench which is capable of supporting a
load of mixer’s weight. For safety, the mixer should be
BOLTED
in position using all four
holes located in the legs.
-
DO NOT attempt to lift the mixer alone.
-
Clean the mixer before use. It is normal for the factory to apply a
generous amount of grease in and on the machine before initial use.
-
During the transportation or fitting, please do not lean over 35 degree
to avoid the gear oil leaking from the gear oil container.
-
Please use forklift to transporting. Please refer to
Figure 1
.
ELECTRICAL CONNECTION
CAUTION:
NEVER USE EXTENSION CORD. Low amp supply could damage the mixer or cause a
fire
.
Before connecting this machine to the electrical supply, check that the details on the rating
plate (located on the rear of the machine) correspond to the details of your electrical connection.
The mixer is supplied with a trailing lead fitted with a molded plug. If the style of plug is
unsuitable for the socket you plan to use, the plug must be cut off and replaced with an
appropriate plug.
Machines are fitted with a color coded three core cable as follows:
(1)
Brown: Live
(2)
Blue: Neutral
(3)
Green/Yellow: Earth
As the color of the wires may not correspond to the colored markings identifying the terminals in
your plug, you should proceed as follows:
-
The wire which is colored blue must be connected to the terminal which is marked with
the letter N or colored black.
-
The wire which is colored brown must be connected to the terminal which is marked with
the letter L or colored red.
-
The wire which is colored green/yellow must be connected to the terminal which is
marked with the letter E or colored green.
NOTE:
In terms of the
3-phase
, when the mixer is located and connected with the plug,
please
make sure that the shaft goes clockwise
. (Same direction as the arrow sticker that located on the
front of the machine) If the shaft goes counterclockwise, please replace the wires: R.S.T. (USA) L1,
L2, L3, (Europe). To replace the wires each other until the shaft goes clockwise.
Figure 1